Owners Manual

TimeFactor User Guide The Footswitches

pair of Presets is cued but the new Preset is not yet loaded. The next time that either the Left

or Middle Footswitch is pressed, the corresponding Preset will load from the cued Bank.

Note: If the previous loaded Preset is in Bypass when the footswitch is pressed, the newly

loaded Preset will be Active.

Note: Edited Presets will be lost if they are not saved before loading another Preset.

Active Banks

If 100 Presets are more than you need, and you’d like to make it quicker and easier to find

and load your Presets, the number of active Banks can be limited. Only the Banks that are

active will show up when loading. While only active Banks can be loaded, Presets can always

be saved to all Banks. Inactive Banks are not erased and can be made active at any time.

When limiting the number of Banks, you have the ability to deactivate both the lower Bank

numbers and the higher Bank numbers. For example, if you only want 5 active Banks, but you

want them to range from Banks 6-10, you can adjust the low number and the high number

separately.

The factory default sets the number of active Banks to 50. To limit the number of active

Banks:

1) Press and hold the Encoder and Right Footswitch simultaneously for a few

seconds to enter System Mode. Release the Encoder.

2) Turn the Encoder until [UTILITY] is displayed.

3) Momentarily press the Encoder.

4) Turn the Encoder until [BANKS] is displayed.

5) Momentarily press the Encoder.

6) Turn the Encoder to adjust the high number of banks from H1 to H50.

7) Momentarily press the Left Footswitch to adjust the low number of banks

from L1 to the high value indicated by the H.

8) Press and hold the Encoder and Right Footswitch simultaneously for a few

seconds to exit System Mode.

Tempo

Tempo ON/OFF

Tempo is turned ON or OFF by momentarily pressing the Encoder. When Tempo is ON, the

Tempo LED flashes at the Tempo rate. With Tempo OFF, the Tempo LED is OFF.

When Tempo is ON, DLY Time A and DLY Time B are set in rhythmic sub-divisions of the beat

i.e. note values from 0 delay to a whole note in common note increments rather than in ms.

When Tempo is OFF, you can set the delay time by tapping the Tap Footswitch in Play Mode.

In this case, Delay Time A and B are set to the same value.

Tap Tempo

In Play Mode, the Tap Footswitch can be tapped to set the tempo. While tapping, the

Billboard displays the updated Tempo.

Note: When using an Aux Switch to tap tempo, the Billboard will display the tempo value in

both Play and Bank Modes.