Owners Manual

TimeFactor User Guide Mix Control
21
Global - Mix
Mix values are always saved with each Preset. Often however, it’s useful to set the same Mix
values for all of the Presets that you’re using. To do this, use the MIX function under the
System GLOBAL command. When MIX is ON, the Mix values saved with the Preset are
ignored and the current Mix value is used for all Presets.
Turning MIX ON or OFF. The factory default is OFF.
1) Press and hold the Encoder and Right Footswitch simultaneously for a few seconds
to enter System Mode. Release the Encoder.
2) Turn the Encoder until [UTILITY] is displayed.
3) Momentarily press the Encoder.
4) Turn the Encoder until [GLOBAL] is displayed.
5) Momentarily press the Encoder.
6) Turn the Encoder until [MIX] is displayed.
7) Momentarily press the Encoder.
8) Turn the Encoder to select [ON] or [OFF].
Peak LED
The Peak LED lights to indicate that the input signal level is near clipping. Occasional flashing
is OK. If Peak LED is lit solidly, reduce the input level either by reducing the signal level fed to
TimeFactor or by setting the rear panel input switch to the Line position.