User Guide

PitchFactor User Guide The Footswitches
44
Bank Mode
In Bank Mode, the Billboard displays the Bank and Preset Number of the currently running
Preset. The Left and Middle Footswitches are used to instantly select or Bypass either Preset 1
or Preset 2. Presets are stored in pairs and each pair of Presets is called a Bank. There are a
maximum of 50 Banks - a total of 100 Presets.
The Billboard displays the current Bank and Preset number. Banks are numbered from 1 to 50
and Presets are numbered 1 and 2.
Note: The 100 Presets can be based on any of the Effects. You can choose to have all 100
presets based on Diatonic. Or, two based on Diatonic, three based on MicroPitch, five based
on Crystals, etc. - or any combination.
Loading Presets
The Preset numbers correspond to the Left and Middle Footswitches.
To Bypass the Preset, simply press the Footswitch corresponding to the loaded Preset. Press
again and the Preset becomes active.
The following attributes are saved with Presets and recalled when Presets are loaded:
1) Parameter knob values.
2) Tempo/Tap value.*
3) Tempo On/Off status.
4) Expression pedal mapping.
* Note: PitchFactor can be set up to change the Tempo value when a Preset is loaded or to
ignore the value saved with the Preset. While Tempo values are always saved with the Preset,
you may prefer to have your current Tempo stay the same as you switch from Preset to Preset.
Turn GLOBAL TEMPO ON to do that. With GLOBAL TEMPO ON, the Tempo values saved with
the Preset are ignored and the current Tempo value is used. Global is described later in this
User Guide.