User Guide

PitchFactor User Guide The Basics
12
Changing Banks
In Bank Mode, 2 of the 100 Presets are instantly accessible. In order to access the other 98
Presets, you’ll have to change Banks. PitchFactor gives you the ability to turn Banks on and
off. This ability is important for performance – you can choose to only activate the Banks and
Presets that you’ll need. PitchFactor ships with all Banks (1-50) Active.
Let’s try changing Banks. First, be sure that you’re in Bank Mode. Now, tap the Right
Footswitch. As you tap, the display will increment through the Bank numbers from 1 to 50.
When a new Bank is displayed, the Bank is cued and 2 new Presets are ready to go. To load
the new Preset though, you must press one of the other 2 Footswitches. Press the Left Foot-
switch to load Preset 1 from the new Bank or press the Middle Footswitch to load Preset 2.
Note: See System Mode for setting active Bank range and for using AUX Switch to
decrement through the Banks.
PitchFactor Power Up
When PitchFactor turns on it remembers what it was last doing and powers up in the same
mode, running the same Effect, with the same parameter values, same tempo, same system
settings, etc. With power off, relays connect PitchFactor’s inputs directly to its outputs.
Can Two Effects Be Used Simultaneously?
No. When you load an Effect it runs on both channels. Effects can be used as Stereo In/Stereo
Out, Mono In/Stereo Out, or Mono In/Mono Out. PitchFactor is smart enough to know what
cables are connected and to automatically route the signals for your set up.