User Guide

ModFactor User Guide The Basics
10
Changing Banks
In Bank Mode, 2 of the 40 Presets are instantly accessible. In order to access the other 38
Presets, you’ll have to change Banks.
ModFactor gives you the ability to turn Banks on and off. This ability is important for
performance – you can choose to only activate the Banks and Presets that you’ll need.
ModFactor ships with all Banks (1-20) Active.
Let’s try changing Banks. First, be sure that you’re in Bank Mode. Now, tap the Right
Footswitch. As you tap, the display will increment through the Bank numbers from 1 to 20.
When a new Bank is displayed, the Bank is cued and 2 new Presets are ready to go. To load
the new Preset however, you must press one of the other 2 Footswitches. Press the Left
Footswitch to load Preset 1 from the new Bank or press the Middle Footswitch to load Preset
2.
ModFactor Power Up
When ModFactor turns on it remembers what it was last doing and powers up in the same
mode, running the same Effect, with the same parameter values, same tempo, same system
settings, etc. With power off, relays connect ModFactor’s inputs directly to its outputs.
Can Two Effects Be Used Simultaneously?
No. When you load an Effect it runs on both channels. Effects can be used as Stereo In/Stereo
Out, Mono In/Stereo Out, or Mono In/Mono Out. ModFactor is smart enough to know what
cables are connected and to automatically route the signals for your set up.