User Manual

H9 User Guide System Mode
40
[XMT.MAP] – Create a MIDI Program Change Transmit Map
When the Left Footswitch loads a Preset, a MIDI Program Change message can be
transmitted from the MIDI Out jack or USB to control an external device - e.g.,
another Eventide Stompbox, an Eventide Eclipse, an Eventide H8000FW, etc.
To Create a MIDI Program Change transmit map, press the HOTKNOB button to
access the MIDI transmit map for editing.
The Left field displays the Preset number (P1 to P99). The right field displays
either OFF or the Prg No. (0-127). Default map: Prg No. 0-99 map to Presets P1 to
P99.
Press the Left Footswitch to select Preset field (indicated by the flashing Left
Footswitch LED), turn the Encoder to select the Preset.
Press the Right Footswitch to select Prg No. field (indicated by the flashing Right
Footswitch LED), turn the Encoder to select the corresponding number.
Note: MIDI Program Change Transmit must be enabled in order for the H9 to
transmit Program Change messages. MIDI Program Change Transmit is turned ON
or OFF in the MIDI menu. Default is OFF.
Note: When an H9 Preset is recalled with a MIDI program change message, MIDI
Program Change messages are not generated.
Press the PRESETS button once to back-up one level to MIDI menu.
Press the PRESETS button twice to go to top level System menu.
[CTL.XMT] – MIDI Continuous Controller Transmit Enable (ON, OFF)
Press the HOTKNOB button to select. Turn the Knob to set MIDI Continuous
Controller transmit ON or OFF. This setting determines if Parameter transmit MIDI
control messages are enabled.
Press the PRESETS button once to back-up one level to MIDI menu.
Press the PRESETS button twice to go to top level System menu.
[PGM.XMT] – MIDI Program Change Transmit Enable (ON, OFF)
Press the HOTKNOB button to select. Turn the Knob to set MIDI Program Change
transmit ON or OFF. If ON, a MIDI Program change message is transmitted
whenever a Footswitch is pressed for Preset load.