User Manual

H9 User Guide System Mode

[RCV.MAP] – Create a MIDI Program Change Receive Map

MIDI maps are an efficient way to instantly recall any of the H9’s Presets using

your favorite MIDI controller (pedal board, sequencer, etc.). Press the HOTKNOB

button to select and create a MIDI Program Change Receive Map. This function

sets the corresponding Preset that is recalled when a MIDI Program Change

message is received. (Referred to as Prg No. from here on.)

Note that if a Preset is saved “Bypassed,” when it is loaded by using a MIDI

Program Change command the Preset will load but the pedal will be Bypassed.

The Left Field displays the Prg No. (0-127) and Right Field displays either the

Preset Number (P01-P99) or one of various Bypass options described below, or

OFF. The two fields are delimited by a decimal point [127.P99]

There are two ways to select the MIDI Prg No: manually or using Learn Mode. To

select manually, with the Left Footswitch LED flashing, turn the Knob to select the

desired Prg No. from 0 to 127.

To use Learn Mode, press the Left Footswitch again. In LEARN mode, the Prg. No.

will be automatically set when a MIDI Program Change message is received.

Pressing the Left Footswitch exits LEARN mode.

Press the Right Footswitch to select the Preset field (indicated by the flashing

Right Footswitch LED) and turn the Knob to select the Preset.

To map another Prg No. to another Preset, press the Left Footswitch again to

select the desired Prg No., then the Right Footswitch to map it to the desired

Preset.

Default map: Prg No. (1-99) map to the 99 Presets (P01-P99).

As well as using MIDI program change to load a preset, this message can also be

programmed to directly control the unit’s BYPASS setting. With the Right

Footswitch LED flashing, turn the Knob counter-clockwise to select:

[OFF] Unassigned

[BYP] BYPass the unit

[ACT] Make the unit Active, i.e., not bypassed.

[TOG] Toggle between bypass and active.

Press the PRESETS button once to back-up one level to MIDI menu.

Press the PRESETS button twice to go to top level System menu.