User Manual

H9 User Guide System Mode

[XMT CC] – Expression Pedal/Aux Switch transmit MIDI Continuous Control

The H9’s Expression Pedal and Aux Switches can be used as MIDI controllers.

Here’s how it works: Press the HOTKNOB button to select [XMT CC]. You will see

two fields (split display) with the left side of the display showing the Control

Source and the right side the Destination. The two fields are delimited by a

decimal point [PDL.C15].The Left Footswitch LED is flashing (if it’s not, press the

Left Footswitch to select this field) showing this to be the selected field for

editing.

To Select the Control Source

Turn the Knob to select the Control Source. The choices are:

[PDL] Expression Pedal

[KB0]…[KB9] - Parameter Control Knobs

[TIP] Aux Switch Tip

[RNG] Aux Switch Ring

[T+R] Aux Switch Tip+Ring

Note: Assigning parameter knobs (KB0-KB9) allow you send MIDI messages

‘through’ the H9 when using H9 Control.

To Assign the Control Source to a Destination

Press the Right Footswitch to select the MIDI Continuous Control that will be

assigned to the H9 Control Source. The choices are:

[OFF] – Control Source unassigned

[C0] – [C99] - MIDI Continuous Controller from 0 to 99

Press the Left and Right Footswitches to toggle between Source and Destination

to make as many assignments as you wish. The default patch is as follows:

[PDL.C15] and [KB0.C22] through [KB9.C31]

Press the PRESETS button once to back-up one level to MIDI menu.

Press the PRESETS button twice to go to top level System menu.