User Manual

H9 User Guide System Mode

Push the Left Footswitch again to set the parameter’s maximum value [MAXVAL].

Turn the Knob to adjust the maximum value. The value is displayed while you’re

turning the Knob and times out to display the selected [MAXVAL] when the Knob

is idle.

Remember, the parameters controlled in this mode are system-wide and will

apply to all Presets.

Note: While it is possible to assign more than one external controller to any

parameter, doing so is likely to cause confusion and is not recommended. Keep in

mind that, if you have previously assigned a MIDI CC to a control destination, you

may want to clear the assignment before setting up a new assignment. To clear,

select the destination (parameter) and select the source (MIDI CC) as [---].

To Setup the External Control Source

Press the Right Footswitch to select the external control source field for editing.

There are two ways to select an external control source - Manual Select or Learn

Mode.

For Manual Select simply turn the Knob to choose the MIDI Control Source. The

choices are:

[---] – No patch

[BND] – MIDI Pitch Bend

[C0] – [C99] - MIDI Continuous Controller messages from 0 to 99.

To use the Learn Mode to select the external control source, Press the Right

Footswitch again. “LEARN” is displayed prompting you to send a MIDI message for

automatic Control Source assignment. Press the Right Footswitch again to exit

LEARN mode and revert to manual source selection.

Press the Left and Right Footswitches to toggle between Source and Destination

to make as many assignments as you wish.

The default patch are as follows:

KB0-KB9 are patched to C22-C29. The default patch is unassigned [---] for all

other [RCV.CTL] destinations.

Press the PRESETS button once to back-up one level to MIDI menu.

Press the PRESETS button twice to go to top level System menu.