User Manual

H9 User Guide System Mode

Here’s how it works: Press the HOTKNOB button to select [RCV.CTL]. You will see

two fields (split display) with the left side of the display showing the Destination

and the right side showing the Control source. The two fields are delimited by a

decimal point [BYP.BND]. The Left Footswitch LED is flashing (if it’s not, press the

Left Footswitch to select this field) showing this to be the selected field for

editing.

To Setup Destination

Turn the Knob to select an external control destination - the H9 parameter or

function which will be controlled from an external source. The choices are:

[BYP] – BYPass the unit

[PR+] – Increment Preset number

[PR-] – Decrement Preset number

[TAP] – Tap tempo switch function

[PSW] – Toggle or enable the Performance Switch function

[HK] – HOTKNOB patch

[KB0]…[KB9] - Parameter Control Knobs

[ACT] – Active (Enable Effect – unBypass)

[TOG] – Toggle between Active and Bypass

[TUN] – Tuner

Performance Switch [PSW] – The Performance Switch is used for ‘infinite repeat’

with TimeFactor algorithms, ‘rate change’ with ModFactor algorithms, various

functions with PitchFactor algorithms and ‘HotSwitch’ with Space algorithms.

Refer to the specific algorithm doc for detailed descriptions.

Parameter “Knobs” [KB0]-[KN9] - You can use MIDI CC to control up to 10 virtual

“Knobs.” KB0-KB9 correspond to the ten parameters of the currently running

algorithm. For example, if a Preset based on the Dual Delay algorithm is currently

running, KNOB0 corresponds to the “MIX” parameter. If the H9 is running a Preset

based on the Rotary algorithm, KNOB0 corresponds to the “INTENSITY” parameter.

Press the Left Footswitch to select the Destination (left field of the display) and

turn the Knob to select the virtual Knob (parameter) from KB0 to KB9. Press the

Right Footswitch the assign the Control Source (MIDI CC) to the displayed KB.

When a Parameter Control Knob designator is displayed (KB0… KB9), you can map

the MIDI CC values from 0 to 127 to a selected range of parameter values.

Pressing the Left Footswitch with a KB selected will display [MINVAL]. Turn the

Knob to set the minimum value. The value is displayed while you’re turning the

Knob and times out to display the selected [MINVAL] when the Knob is idle.