User Manual

H9 User Guide System Mode

Note: The cursor will “wrap around the display,” i.e. Pressing the Left Footswitch

will move to the left by one character at a time until it gets to the first character,

then it will jump to the Preset Number field. Pressing the Left Footswitch again

will jump to the last character.

Note: A ‘phantom’ character is always present at the name’s end allowing

characters to be added past the end. This cannot be deleted; it’s removed on exit.

Press the PRESETS button once to back-up one level to BLUE menu.

Press the PRESETS button twice to go to top level System menu.

[BYPASS] – Select Bypass Mode

After entering System Mode, turn the Knob to select [BYPASS] and then press the

HOTKNOB button to enter Select Bypass Mode. Turn the Knob to select either

[BYPTYP] or [KIL.DRY].

[BYPTYP] – Choose Bypass Type (DSP, RELAY, DSP+FX)

Press the HOTKNOB button to select. Turn Knob to select DSP, RELAY or DSP+FX.

When [DSP] is selected, Bypass sends the audio at the DSP’s inputs directly to the

outputs without any effects processing.

When [RELAY] is selected, Bypass employs a pair of relays to “hardwire” the inputs

to the outputs, giving a “true bypass.”

When [DSP+FX] is selected, Bypass sends the audio at the DSP’s inputs directly to

the outputs with the decaying ‘tail’ of the current effect mixed in.

Press the PRESETS button once to back-up one level to BYPASS menu.

Press the PRESETS button twice to go to top level System menu.

[KILDRY] – Kill Dry Audio (NO, YES)

Press the HOTKNOB button to select. Turn Knob to enable/disable [KILDRY].

When [KILDRY] is enabled (YES), the dry signal is removed from the output and the

H9 only outputs a 100% wet level. For some of the Presets the Intensity control

acts as a Wet/Dry Mix control. For these Presets, if [KILDRY] is YES, the Intensity

control is disabled.

Press the PRESETS button once to back-up one level to BYPASS menu.

Press the PRESETS button twice to go to top level System menu.