User Manual

H9 User Guide HOTKNOB & Expression Pedal

Note: The terms [MINVAL] and [MAXVAL] actually refer to the values at the

counterclockwise and clockwise extremes of the Knob’s travel. In other words, it

is possible to set the [MINVAL] to 100msec of delay (for example) and the

[MAXVAL] to 1msec of delay.

Note: Changing the HOTKNOB patch will also change the Expression Pedal patch -

they’re one and the same.

Exit HOTKNOB Patch Mode

To exit HOTKNOB patch operation Press and Hold the HOTKNOB button for 2

seconds. The HOTKNOB button LED will light solidly and the display will show the

name of the parameter assigned the HOTKNOB if a single parameter is patched. If

multiple parameters are patched [HOT+] is displayed. The Edited LED is lit to

show that preset is modified but not saved.

Save HOTKNOB Patch

Press and Hold the PRESETS button to save the Preset with your HOTKNOB patch

assignment.

Clear a HOTKNOB Patch

To completely clear a HOTKNOB patch, Press and Hold the HOTKNOB button. The

HOTKNOB switch LED will come on. While holding the HOTKNOB button press the

PRESETS button until the display scrolls CLR HK PRESS PRESETS, then release all

keys. Pressing the PRESETS button again will then clear the patch; pressing any

other button exits HOTKNOB patch clear leaving the patch intact.

If multiple parameters are patched to the HOTKNOB you have the option of

unpatching one parameter at a time. To do so, set the parameter’s MINVAL and

MAXVAL to the same value.

View HOTKNOB Patch Destinations

To view the list of parameters assigned as HOTKNOB patch Press and hold

HOTKNOB button while holding down the X, Y or Z button. Use the Knob to scroll

through the list of parameters names assigned to the HOTKNOB.