User Manual

H9 User Guide Presets, Algorithms, Parameters

Saving Presets

To save a Preset:

1) Press and hold the PRESETS button for a few seconds, the current Preset

Number and 4 characters of the Preset Name are displayed. Release the

PRESETS button. The Preset number flashes and the “Edit” LED is lit (far

right decimal point).

2) Turn the Knob to select the desired Preset Number for editing. When

saving, all Preset numbers are available even if you’ve limited the

number of active Presets.

3) Press the Right Footswitch and the first character of the Preset name will

flash. Turning the Knob will change this character. Preset names can

have up to 16 characters. The available character set is '0-9', 'A-Z'.

4) Use the Left and Right Footswitches to traverse the display, selecting the

character to be edited by the Knob. (The active character for editing is

always flashing.) Repeated pressing of the Right or Left Footswitch will

traverse through the name, one character at a time, flashing the selected

character. Press and hold Left Footswitch to DELETE the currently

flashing character.

5) Press and hold the Right Footswitch to INSERT a character before the

currently flashing character.

6) To save the Preset, press and hold the PRESETS button a second time.

The Display will show [SAVED].

7) After a short time, the Save mode is exited.

8) To exit Save without saving, press and release the PRESETS button again

without holding it or press the Knob. Upon exiting Save mode without

saving, [NO SAV] is displayed and, after a few seconds of inactivity, the

display reverts to showing the currently loaded Preset.”

Note: You must PRESS and HOLD the PRESETS button to save. If you press and

release quickly, the new Preset will not be saved. This is intentional. When you

save a new Preset, you overwrite the old Preset. The H9 is designed to assure that

saving is a deliberate act. The Preset number corresponding to the currently

running Preset will flash as a warning that saving in this location will overwrite the

currently loaded Preset.

Note: The cursor will “wrap around the display,” i.e. Pressing the Left Footswitch

will move to the left by one character at a time until it gets to the first character,

then it will jump to the Preset Number field. Pressing the Left Footswitch again

will jump to the last character.