User Manual

H9 User Guide The Basics
8
load automatically (no need to press the Left Footswitch to load when using the
Knob with the Preset button lit). When a Preset loads, the full Preset Name scrolls
once across the display after which the Preset Number is solidly lit.
Note: See System Mode for setting active Preset range and for using an AUX
Switch to increment/decrement through the Presets.
Using the Right Footswitch to Tap Tempo or Parameter Values
To turn Tap Mode ON/OFF, press and hold the right footswitch for 2 seconds. A
blinking Tap LED indicates that both Tap Mode and Tempo are ON. Under these
conditions, tapping the Right Footswitch will adjust the Tempo and the display
will indicate the Tempo in BPM.
A solidly lit Tap LED indicates that Tap Mode is ON but Tempo is OFF. Under these
conditions, tapping the Right Footswitch will set the value of the given algorithm's
"tappable" parameters. The display will indicate the value for those parameters
(usually in msec or Hz).
To turn Tempo Mode ON/OFF, simultaneously press the Right Footswitch and the
PRESETS button.
Tip: While tapping (and with the display indicating BPM or parameter value), you
can use the Knob for fine tuning.
Tuner
Press both footswitches to enable the tuner. The LightRing indicates flat/sharp
with twelve o’clock indicating ‘in tune’. The display shows the note. Press either
footswitch to exit.
H9 Power Up
When the H9 turns on it remembers what it was last doing and powers up in the
same mode, running the same Preset, with the same parameter values, same
tempo, same system settings, etc. With power off, relays connect the H9’s inputs
directly to its outputs.
Can Two Presets Be Used Simultaneously?
No. When you load a Preset it runs on both channels. Presets can be used as
Stereo In/Stereo Out, Mono In/Stereo Out, or Mono In/Mono Out and Stereo
In/Mono Out. The H9 is smart enough to know what cables are connected and to
automatically route the signals for your set up.