Specifications

85
Alternatively, you can use Word Clock as a
clock source. H8000/H8000A users must enable
Word Clock before use, on the misc or clock
menu pages respectively in the SETUP area.
Word Clock is always enabled on H8000FW, so it need not be enabled.
Then you can select WORDCLK as the external
clock source on the clock menu page in the
SETUP area.
The rate of the external clock is displayed in the "Sample Rate: xxxxx" field. In the
example shown two screens above, the actual frequency of the external signal is 48001Hz.
External sampling rates can range from ~30kHz to 53kHz and 61kHz to ~99kHz.
 See Sampling Rates on page 79 for information on speed modes.
 See Word Clock Termination on page 88 for information on connecting Word Clock.
Selecting a clock source when connected to a computer (H8000FW only)
When an H8000FW is connected to a computer by FireWire, the clock source is set by the computer
and the source control on the H8000FW is disabled. This is because it is important that the
computer and the H8000FW remain synchronized.