Specifications

77
To adjust the level of the outputs from -100dB
to 0dB, go to the output menu page in the
LEVELS area. If you’re using the analog outputs
on an H8000 (not an H8000A or H8000FW), Out
7
and Out 8 control the level before digital to analog conversion. Unless you have a good
reason for doing otherwise, leave these at zero!
If you’re using the analog outputs on an
H8000FW (not an H8000), explicit analog
parameters control the level before digital to analog
conversion. Again, unless you have a good reason
for doing otherwise, leave these at zero!
A better place to adjust the analog output level -
90 to 3 dB is on the "bottom" outputs menu
page in the LEVELS area. These adjustments are
made after the digital to analog conversion. Making
your adjustments "post D/A" will generally result in lower noise and distortion than
making them "pre D/A."
 Note: These parameters can be "remote controlled" via MIDI or the foot pedal jacks. To learn how, read:
Setting Up the External Controllers
on page 92.
External Modulation and Trigger Menu Pages
on page 96.
Remote Controlling P
arameters on page 111.