Specifications

To monitor the input levels, go to the meter

menu page in the LEVELS area. Change Source

to inputs. Select post-fade if you would like

to monitor levels after the aforementioned cuts.

Select pre-fade if you would like to monitor levels before the aforementioned cuts.

It is possible to overdrive an input to the H8000FW, decrease that overdriven level at the

inputs page, and show no clipping on the Level Meters when viewing post-fade! To avoid

such a situation, it is advisable that you boost/cut the signals coming into the H8000FW

at their source. Doing so also results in a better gain structure! The moral? Use the

boost/cut on the inputs page only as a last resort.

 Note: All of the parameters discussed in this section can be "remote controlled" via MIDI or the foot pedal

jacks. To learn how, read:

Setting Up the External Controllers

on page 92.

External Modulation and Trigger Menu Pages

on page 96.

Remote Controlling P

arameters on page 111.