Specifications

Signal Flow Example

Now that you’re familiar with the actual menu pages employed in signal routing, let’s run

through a realistic, but fairly involved signal routing. Four main steps are required for

routing any configuration:

 Select "sources" for the

Main in

"input block" at SETUP / inputs.

 Select "sources" for DSP A’s inputs at SETUP / dsp A.

 Select "sources" for DSP B’s inputs at SETUP / dsp B.

 Select "sources" for the

Main out

"output block" at SETUP / outputs. (Recall

that the analog and AES/EBU outputs are always fed from here.)

Optionally:

 Select "sources" for the ADAT outputs at SETUP / outputs (third menu page).

For the H8000FW:

 Select "sources" for AES11/18 outputs at SETUP / outputs (fourth menu page).

 Select "sources" for FIREWIRE1 outputs at SETUP / outputs (fifth menu page).

 Select "sources" for FIREWIRE2 outputs at SETUP / outputs (sixth menu

page).

Once the routing is configured, you can, at your discretion, change levels at:

 The analog inputs. Use

LEVELS / inputs

 Use the "bottom" menu page for pre-A/D adjustments.

 Use the "top" menu page for post A/D adjustments (note – using the pre-A/D control will

give a better signal)

 The digital inputs. Use LEVELS / inputs.

 The inputs to DSP A. Use LEVELS / dsp A.

 The inputs to DSP B. Use LEVELS / dsp B.

 The outputs of DSP A. Use LEVELS / dsp A.

 The outputs of DSP B. Use LEVELS / dsp B.