Specifications

184
Note that the sequence the devices are listed is a very important consideration. As Built-in
Audio precedes Eventide H8000FW in the listing, it consequently reserves the first two of
the total 18 audio channels for the Built-in Audio device, leaving channels 3-18 for the
H8000FW. This will be of paramount importance when routing the audio to the
H8000FW.
After all parameters for the Aggregate Device are established, your Audio MIDI Setup
screen will display like this:
You may view the setup of the Aggregate Device by clicking the Configure Device
button.
For more information on creating Aggregate Audio Devices, consult Help from your
Macintosh’s menu bar.
Routing Audio to the H8000FW
Now that you have created an Aggregate Audio Device, you must configure the
H8000FW to accept and generate audio signals.
To do this

Press the Program button on the H8000FW’s front panel until it blinks. Check to be
sure the Routing screen is displaying.

Using the front panel’s keypad, enter 20, then ENT. Finally, press the Select
button.