Factory Harmonizer Native Plug-In User Guide
Table Of Contents
- Introduction
- Registration, Activation, and Installation
- Using H3000 Factory
- Plug-in Panel Details
- Eventide Preset Bar
- H3000 Front Panel
- Preset Parameter Panel
- Program Page
- Left and Right Inputs
- Noise Input
- Full Scale Input
- Side Chain Input
- Mod Knob Input
- Function Generator
- Effects Block Mod Input and Patching Section
- Effect Block MODULATION Section
- Effect Block PARAMETERS Section
- Delay 1 and 2 Effect Block Parameters
- Pitch Shift 1 and 2 Effect Block Parameters
- Filter 1 and 2 Effect Block Parameters
- Ampmod 1 and 2 Effect Block Parameters
- Scale 1 and 2 Effect Block Parameters
- LFO 1 and 2 Effect Block Parameters
- Envelope 1 and 2 Effect Block Parameters
- Mixer 1–4 Effect Block Parameters
- Expert Page
- Function Page
- Conclusion
Chapter 3
Using H3000 Factory
3.1 Patch Cables and Blocks
The H3000 Factory Plug-In contains 18 effect blocks in a patchable interface. These blocks are located
in the lower left of the plug-in, on the Program Page. Clicking on each input, output, or effect block will
show that blocks detail page, which includes all relevant parameters, modulation and routing. To create
effects in H3000 Factory, you connect the effects blocks together using virtual patch cables. Click on the
desired block’s Output jack and drag the resulting cord over to any block’s Input jack. The connection
is made when you release the mouse button. You may start with an effects block’s Input jack and drag
to an Output jack as well. Audio and Mod signals can be interconnected unleashing incredibly dynamic
effects. Patch cords are also color-coded for your convenience:
• Yellow = Left audio channel
• Red = Right audio channel
• Blue = Mod signal
• Orange = This will identify a side chain audio signal or a mix of audio and Mod signals.
• White = not connected to signal path
5