User Manual

www.event-lighting.com.au
5
Refer to the DMX Chart below for more information on each mode.
Set Manual Control
Manual Control allows you to set Dimmer, Dimmer Fine and Strobe values through the control
panel.
Select “Dimmer” then press Enter.
Select “DIM” for Dimmer, “D_F” for Dimmer Fine, or “STO” for Strobe, then press Enter.
Use Up and Down to set the desired value.
Press Enter to confirm and save.
Set Dimmer Curve
Select “Curve” then press Enter.
Use Up and Down to set the desired dimmer curve.
Press Enter to confirm and save.
Set Fan Mode
Select “Fan” then press Enter.
Use Up and Down to set the desired fan curve.
Press Enter to confirm and save.
DMX Chart
• This fixture is controlled by the universal DMX 512 protocol. The DMX address is the first
channel used to receive instructions from the external controller. For independent control,
each fixture must be assigned a unique address for each of its control channels. For
example, this device has three channel modes: 1/2/3, if it’s set to 3 channel mode, and
there are several fixtures need to be independently controlled, we just simply address
first fixture at 1, and second fixture at 4, third one at 7, etc.
• If multiple fixtures have the same DMX address, they will behave synchronically.
• Display will flash when no DMX signal is received.
Mode/Channel
Min.
DMX
Max.
DMX
Function
1 Ch
2 Ch
3 Ch
1
1
1
0
255
Dimmer
2
2
0
255
Dimmer-Fine
3
0
255
Strobe, slow to fast