User Manual

www.event-lighting.com.au
2
Safety Instructions
Warning
• Do not open this fixture, there is no user-serviceable parts inside. Risk of electric shock.
• Do not look directly at the light source when the fixture is on.
Caution: This unit’s housing may become hot during and after operation.
• Install this fixture in a location with adequate ventilation, at least 50 cm from adjacent
surfaces.
• Do not leave any flammable material within 50 cm of this unit while operating or
connected to power.
• Use a safety chain when mounting this fixture overhead.
• Do not operate this device in any location where excessive dust, heat, water or humidity
may affect it.
• Do not operate this fixture if the housing, lenses, or cables appear damaged.
• Do not connect this fixture to a dimmer or rheostat.
• ONLY connect this fixture to a grounded and protected circuit.
• ONLY use the hanging bracket to carry this fixture.
• In case of a serious operating problem, stop using immediately.
• The maximum ambient temperature is 40° C. Do not operate this fixture at higher
temperatures.
Power Input
This fixture has an auto switching power supply that works with an input voltage range of 110-
240V AC, 50/60 Hz.
IR Remote