NITROBALL2 LED Rotating Ball with 5 x 15w HEX (6-in-1) LEDs. USER MANUAL This manual contains important information about the safe installation and use of this product Please read this instruction manual carefully before installing or operating Please keep these instructions in a safe place for future reference V1.
Contents 1. Safety Instructions 2 2. Installation 3 3. Features 3 4. Product Overview 4 5. Menu Operation 5 6. DMX Table 5 7. DMX Address Setting 7 8. Error Messages 8 9. Rigging 8 10. Cleaning and Maintenance 8 11. Technical Data 9 12.
Introduction Thank you for the purchase of your NITROBALL2 rotating LED Ball by Event Lighting Lite. Please read these instructions carefully to ensure the product is well look after and used correctly to avoid any potential problems. Please note that as part of our ongoing commitment to continuous improvement and product development, the specifications in this manual are subject to change without notice.
- Never carry the fixture directly from the cord. Carry by holding the base of the unit, and only move when unit is upright. - Avoid direct eye exposure to the light source while it is on. 2. Installation: Caution: For safe mounting of this product, please read the following carefully. - Use the included rapid lock clamp to attach to lighting stand, trussing or bar, together with safety chain. See section 9 for detailed instructions regarding rigging.
4. Product Overview 1. 2. 3. 4. LED Display MODE/ESC button UP button (UP） DOWN button (DOWN） 5. Enter button (ENTER） 1. Signal input 2. Signal output 3. ON/OFF switch 4. Fuse 2A 5. Power In 6.
5. Menu operation A001 001-512 DMX mode AuTo Au0F AUTO mode OFF AuTo AUTO mode ON SOND SOUND mode rdoF rdoF Sound sensitivity ASTE Mast Master unit Alon Slave unit rdoF DISPLAY REVERSE OFF rdon DISPLAY REVERSE ON dFoF DEFAULT OFF dFon DEFAULT ON REST RESET rdoF dFoF REST Notes: 1. The display flickering slowly indicates the current MENU option. If the display is flickering quickly, the data shown on the display will become current once entered. 2.
3 0-255 4 0-255 Pan speed（ invalid during endless rotation, 226-235. Light OFF when scanning，236-255：max speed） Red dimming 5 0-255 Green dimming 6 0-255 Blue dimming 7 0-255 White dimming 8 0-255 Yellow dimming 9 0-255 UV dimming 10 0-255 0-15 No function 16-95 Synchronous strobe – strobe speed 96-175 Strobe Flash once per second. Flash Duration from short to long.
7. DMX Address Setting When being used in conjunction with a DMX controller, each fixture must be set a specific starting address. When receiving signal, fixture will receive channel control signals of this address from the DMX controller. For simplicity, the user can use the same address for multiple fixtures but this will result in each fixture providing exactly the same output and fixtures with the same DMX address cannot be individually controlled.
DMX-512 connection with DMX terminator A DMX terminator helps to reduce ‘noise’ on the DMX chain, and makes the light respond to control more accurately. It should be plugged in to the last fixture in any chain. For Terminator connections please see below: 8. Error Messages In the event of an error or problem within the fixture, the display will show an error message such as “PAN-ERR”. A pan error could be caused by an obstruction to the rotation of the ball.
Insert the quick-lock fasteners of the first holder into the respective holes on the base of the product. Tighten the quick-lock fasteners fully clockwise. The mounting bracket can then be attached to a stand, trussing or lighting bar securely. Be sure to use a safety chain which connects through the lug with the hole in it on the base and around the trussing or bar on which the product is being mounted. 10.
