User Manual

www.event-lighting.com.au
3
Set Up of CB1G
Lay the CB1G - Crowd Barrier Gate in line with the previous unit, with the sloped front facing in
the direction the crowd will be, using the bolt inserted to the previous unit as a guide to line up
the crowd barrier gate. Lift the gate into place, following the same method as the previous crowd
barrier unit.
3. Push the bolt through both units, until there is enough room to tighten the nut to the bolt. Be
sure to tighten the nut, using a spanner.
4. Using an allen key, turn the floor latch anti clockwise until it has grabbed onto the adjacent unit
and can move no further.
5. Using an allen key, turn the wall latch anti clockwise until it has grabbed onto the adjacent unit
and can move no further.
Note: Ensure the hand rails line up where they should be, if not loosen up the bolts with the allen
key and the coffin latch and realign and tighten again.