Phau Ntawv Qhia

Turn the stroller upside down.

Install H-frame P to stroller frame legs Q until they lock into

place with audible clicks.

Hold the rear wheel/axle assembly so the brake levers R face

toward the handle and console.

Slide the brake housings onto the H-frame until they lock into

place with audible clicks.

Pull upward on the rear wheel/axle assembly to make sure it

is locked securely.

ASSEMBLING YOUR STROLLER

Slide the front wheel assembly S over the front frame leg T

until the locking tab U locks into place with an audible click.

Repeat for other side.

Note: To remove each swivel wheel, press locking tab U and

slide the wheel off the leg.

Insert the canopy support tubes V into the canopy hinges on

the stroller W until they lock into place with audible clicks.

Pull upward on the canopy tubes to make sure they are

locked securely.

Bring the parent’s console B up to the parent’s handle C.

Gently pull out the side of the console and guide the hole X

over the post Y. Repeat on the other side of the parent’s

console.

Step on the rear brake levers B to lock the rear wheels on

the stroller.

To release the brakes, lift up on the brake levers.

USING YOUR STROLLER

Pull canopy hoop A forward to extend canopy.

Push canopy toward handle to close.

Begin assembly of the rear wheels and axle assembly by discarding all packaging.

Slide one wheel H and a steel washer I onto the axle J. Insert a clevis pin K through the end of the axle J to secure the

wheel, as shown. Make sure the clevis pin is completely pushed through the hole in the axle

, and make sure the brake

housings L are facing the same direction. Note: An extra clevis pin and steel washer are included for your convenience.

Install the hub cap M on the wheel by lining up the notch N with the tallest rib O in the wheel hub. Insert the hub cap

completely until it snaps into place. Repeat on the other side.