Troubleshooting guide

Page 78
The Digital Control Board
The buttons on the board function as
follows: (Refer to Figure 15. The touch
pad buttons are labeled with the white
numbers 1 through 6)
1. The heat advance button (1) will
advance the setting between level 1 and
5. Once you reach level 5, it will drop
back to level 1. Each level has a LED
light to indicate where the board is set.
2. The On/Off button (2) turns the
stove on and also acts as the toggle
switch to reset the board after the board
switches to Diagnostic mode.
3. The auger button (3) will allow the
customer to manually auger Corn into
the burn pot on start up when needed.
4. The Draft Trim (4) button allows for
adjusting the Exhaust fan voltage on
level 1 only. Push the button and the
LEDs flash once to decrease the voltage
5 volts. Push the button a second time
and the LEDs flash twice to decrease the
voltage another 5 volts. Pushing the
button a 3
rd
time will reset the voltage to
the normal setting. This adjustment is
helpful when there is a problem with a
chimney that has excessive natural draft
and the stove is going out on the #1
setting because of too much draft.
4. The Feed Trim (5) button will allow
the feed rate to be adjusted on level 1
only. There are 3 levels for the # 1
setting , #1 Normal, #1 High and #1
Low. The LED lights will light up as
follows to indicate which level #1 is
running.
Figure 15
a. The first LED only indicates the
Normal #1 setting. (1.5 second on
time). See Figure 3 on page 66.
b. The first and fourth LED lights
indicate the #1 Low setting. (1.25
second on time) See Figure 4 on
page 66.
c. The first and fifth LED lights
indicate the #1 High setting. (1.75
second on time) See Figure 4 on
page 66.