Troubleshooting guide

Page 66
g. The Auger ON Time for level 1 is adjustable to fine-tune the stove. Once the stove is
turned on the #1 LED should be on. See Figure 3 above - This has an ON Time of 1.5
seconds
h. Press the Feed Trim button (button #5, see Figure 2) once and the #1 and #5 light
will come on. See figure 4 above – This has an On Time of 1.75 seconds.
i. Press the Feed Trim button (button #5, see Figure 2) again and the #1 and #4 light
will come on. See figure 5 - This has an On Time of 1.25 seconds.
j. Press the Feed trim button again and the #1 light (Default Setting) comes back on.
(See Figure 3)
This is a method to Fine Tune the amount of Heat and/or the Burn Characteristics on
the #1 setting by adjusting the Auger On Time of level 1. This adjustment will not
affect levels 2 through 5.
k. The Draft Trim button (button #4, see Figure 2) allows for adjusting the Exhaust fan
voltage on Heat Level 1 only. Push the button and the all of the LED Lights in the
light bar will flash once. (See figure 6 above) This decreases the Exhaust fan voltage
approximately 5 volts below the default setting. Push the button a second time and all
of the LED Lights in the light bar will flash twice. This decreases the voltage
approximately another 5 volts. Pushing the button a 3
rd
time will reset the voltage to
the default setting. This adjustment is available to fine tune the Draft fan voltage
on the #1 Heat Level setting only.
Level 1 On Time
1.50 seconds
Default setting
Figure 3
Level 1 On Time
1.75 seconds
Auger Trim
Figure 4
Level 1 On Time
1.25 seconds
Auger Trim
Figure 5
Draft Trim Button
Adjusts Combustion
fan on level 1 only.
Figure 6