Troubleshooting guide

Page 27
Figure 10
The Digital Control Board
The buttons on the board function as
follows: (Refer to Figure 10. The touch
pad buttons are labeled with the White
numbers 1 through 6)
1. The Advance Heat button will advance
the setting between level 1 and 5. Once
you reach level 5, it will drop back to level
1. Each level has a LED light to indicate
where the board is set.
2. The On/Off button turns the stove on
and also acts as the toggle switch to reset
the board after the board switches to
Diagnostic mode.
3. The Auger button will allow the
customer to manually auger pellets into
the burn pot on start up when needed.
4. The Draft Trim button allows for
adjusting the Exhaust fan voltage on level
1 only. Push the button and the LEDs flash
once to decrease the voltage 5 volts. Push
the button a second time and the LEDs
flash twice to decrease the voltage another
5 volts. Pushing the button a 3
rd
time will
reset the voltage to the normal setting.
This adjustment is only needed when there
is a problem with a chimney that has
excessive natural draft and the stove is
going out on the #1 setting because of too
much draft. See Figure 6 on Page 19.
5. The Auger Trim button will allow
the feed rate to be adjusted on level 1 only.
There are 3 levels for the # 1 setting, #1
Normal, #1 High and #1 Low. The LED
lights will light up as follows to indicate
which level #1 is running.
6. The Thermostat Mode Switch
gives 3 modes of operation for running the
stove.
a. The first LED only indicates the
Normal #1 setting. (1.5 second on
time) See Figure 3 on Page 17.
b. The first and fifth LED lights
indicate the #1 High setting. (1.75
second on time) See Figure 5 on
Page 17.
c. The first and fourth LED lights
indicate the #1 Low setting. (1.25
second on time) See Figure 4 on
Page 17.