Troubleshooting guide

Page 8
The Ashby has several features that allow the unit to be adapted to allow a better fit
under certain conditions.
Adjustable Hopper Instructions
Step 1 – Remove the 15 screws that hold the Hopper Top in place. Cut through the
aluminum taped that seals the hopper and remove the Hopper Top.
Step 2 – The top can be lowered
2”. To utilize the full 2”
adjustment the front corners must
be removed to lower the top.
Break off tabs if needed.
Step 3 – Once the Hopper Top has been lowered to the correct height, use the self-
tapping screw to re-attach the top. Screw the back edge of the top back in place using the
screws that were removed.
Step 4 – After drilling out the 3
holes in the front lip with a 1/8”
drill bit, attach the front lip using
the 3 rivets provided in the
package. The rivets should be
applied from inside the hopper.
Take care not to drop anything
into the hopper.
Step 5 – Once the top is attached,
use the aluminum tape provided
to seal all of the seams. This will
make the hopper airtight again.
Figure 8
Figure 9