Troubleshooting guide

Page 7
Figure 6
6 – Place the Versa Grate Pot in the stove and check the gap between the Shaker Plate
and the bottom of the Grate. The gap should be about 1/16“. A gap that is too large
allows the Shaker Plate to rock back and forth on the Rod like Teeter Totter and that can
create a gap large enough to allow pellets to drop through. If the Bottom of the Grate
actually rests on the Shaker Plate will create noise as the Shaker Plate slides back and
forth. Using a 12” extension for the ¼” hex driver bit is helpful in reaching the screws
that hold the adjustable Front Bushing Plate in place.
Figure 7
7 – Install the Igniter Assembly with the wires going to the right hand side of the stove.
Push the wires through the Conduit Tube and connect them to the Red and White Wire in
the harness.
8 – Install the Igniter Cover over the Igniter. The left Igniter screw serves both the igniter
and the cover.
9 – Install the Finish Plug and place the Lower Panel.