Troubleshooting guide

Page 5
Installing the Multi-Fuel System
Start by covering the hole on
the back side of the unit where
the Rear Bushing Assembly
was removed.
Attach the Cover plate using
the 2 screws that were removed
with the Rear Bushing
Assembly.
Figure 3
Follow the order listed below for in stalling the components.
1 – Insert the Slide-Out Bottom
2 – Place the Coal Rake in the unit,
with the Rod sticking out the front of
the unit. Note the orientation of the
bend. The bend is facing down. See
Figure 5
3 – Put the Multi-Fuel Pot into the
unit.
4 – Insert the Coal Rake into the
slots in the Burn Pot. See Figure 5
Figure 4