Troubleshooting guide

Page 3
This Ashby was designed to be able to switch between the 2 burn systems we offer in our
regular stove line. Following is a description showing how to switch out the burn pots.
Removing the Versa Grate System
Figure 1
Remove the parts shown in figure 1 in the following order:
1 – Lower panel 2 – Finish Plug 3 – Igniter Cover
4 – Igniter Assembly 5 – Pot Assembly 6 – Shaker Plate
7 – Cotter Pin 8 – Spacer 9 – Front Bushing
After pulling the Cotter Pin, the Spacer and the Front Bushing Assembly may be left in
the unit until the Versa Grate system has been pulled from the back side. This will
remove the Shaft/Cage Weldment extending from the back and allow the Spacer and
Bushing Assembly to be removed with less effort.