Troubleshooting guide

Page 1
Ashby-P and Ashby-MF
The Ashby Series of Inserts consists of
the Burn Systems we currently use in
our Stove Line. The Ashby-P uses the
Versa Grate System. The Ashby-MF
uses the Multi-Fuel System
These units also use the new Digital
Control Board that was introduces on
the SCF-Revolution Furnace and the
Lincoln-SCR. Since the fronts of the
boards all look the same, the words,
Non Revolution Stoves along the bot-
tom edge of the board. It can’t be seen
while it is installed on the stove, but it
can be seen as a replacement part. This
way the control boards can be identi-
fied.
The newsletter for Technical and Warranty issues
Ashby Service Manual Addendum
1/5/10
Ashby Control Board 2
How to Remove the Versa
Grate System Pages 3-4
How to Install the Multi Fuel
System Pages 5-6
3
5
How to Install the Versa Grate
System Pages 6-7
How to adjust the Hopper size
6
8
How to remove the Base and
Bolt On Ash Pan
The Built In Vent Clean-Out
System Pages 9-10
9
9
Dual High Limit Switches
The Zero-Clearance Cabinet
How to build the Cabinet
Pages 12-13
11
12
12
How to Install the Cabinet and
Insert into the Zero Clearance
Cabinet
Troubleshooting Flow Charts
for the High Limit Switches
14
15
Troubleshooting Flow Charts
for the Convection Fans
For all Remaining Parts refer to
page 16
15
16
Ashby Wiring Schematic
Ashby Parts Breakdown
Pages 18-20
Ashby-MF Data Chart
Ashby-P Data Chart
18
19
22
23
Ashby Insert Series P &
Series MF
TechNet
Manufactured and Distributed by Even Temp, Inc.
Identifies the Ashby
Control Board