Troubleshooting guide

Page 17
j. The Auger ON Time for level 1 is adjustable to fine-tune the stove. Once the stove is
turned on the #1 LED should be on. See Figure 2 above - This has an ON Time of 1.5
seconds
k. Press the Feed Trim button (button #5, see Figure 1) once and the #1 and #5 light will
come on. See figure 3 above – This has an On Time of 1.75 seconds.
Press the Feed Trim button (5) again and the #1 and #4 light will come on. See figure
4 - This has an On Time of 1.25 seconds.
Press the Feed trim button again and the #1 light (Default Setting) comes back on. (See
Figure 2)
This is a method to Fine Tune the amount of Heat and/or the Burn Characteristics on the #1
setting by adjusting the Auger On Time of level 1. This adjustment will not affect levels 2
through 5.
l. The Draft Trim button (button #4, see Figure 1) allows for adjusting the Exhaust fan
voltage on Heat Level 1 only. Push the button and the all of the LED Lights in the light
bar will flash once. (See figure 5) This decreases the Exhaust fan voltage approximately
5 volts below the default setting. Push the button a second time and all of the LED
Lights in the light bar will flash twice. This decreases the voltage approximately
another 5 volts. Pushing the button a 3
rd
time will reset the voltage to the default
setting. This adjustment is available to fine tune the Draft fan voltage on the #1
Heat Level setting only.
Level 1 On Time
1.50 seconds
Default setting
Figure 2
Level 1 On Time
1.75 seconds
Auger Trim
Figure 3
Level 1 On Time
1.25 seconds
Auger Trim
Figure 4
Fan Button Adjusts
Combustion fan on
level 1 only.
Figure 5