Troubleshooting guide

Page 9 - 9 -
Figure 10
(Lincoln SCR Drive Assembly shown)
Above are the components that make up the Drive system in a unit with the Revolution
Burn Pot Design.
A Gear Motor, 2 Switches and a Drive Shaft are the major components along with several
brackets that mount these components in the unit.
Figure 11 to the left shows a view of the
system when looking directly at the motor
and the switches. It is important to note the
location of Switch 1 and Switch 2.
Switch 1 is not monitored by the Control
Board. It functions only after the Control
Board starts the rotation of the drum in the
burn pot.
Switch 2 is monitored by the Control Board
to make sure the Drum is rotating when it is
supposed to.
Figure 11