Specifications

SCF-050 Manual

Periodic Maintenance

CAUTION: Periodic maintenance should only be done while the Furnace is shut off and

cold.

1. Ashpan. Empty the ash pan when it appears full (approximately once a week). The

frequency of cleaning the ash pan will depend on the quality and amount of fuel being

used. Carefully check to make sure the ash pan door is tightly closed after each

opening.

2. Burnpot and Slide-Out Bottom. Clean burn grate holes whenever needed. Remove

the Burnpot and use a small metal object (Nail, Drill Bit, etc) to clean out plugged

holes. (See Figure 20 below)

The area shown above is located inside the

Furnace Firebox and must be accessed

through the Firebox door.

Figure 20

Burnpot & Slide-out Bottom

Removal

To remove the Burnpot from the Furnace the Coal Rake must be pulled back so the pot

will clear it. Open the Firebox door of the Furnace and you will see 2 Hex head screws.

Follow steps 1 through 4 in the diagram to the left to remove the Burnpot from the

Furnace. To remove the Slide-out Bottom follow steps 1 through 3 in the diagram to the

right.