Specifications
SCF-050 Manual
37
1. The coal Rake. The first step is to push the coal rake in and shave the coals off
the top of the clinker. Once this is done open the door and add a ΒΌ cup of pellets
on top of the coals (See figure 18). To push in the Coal rake, use the Rod Handle
tool shown in figure 20 on page 39.
Figure 18
2. The ash pan. Make sure the Ashpan is not too full to receive a clinker. If the
Ashpan is too full, the clinker may not drop all the way through. This will not
allow the pot bottom to be closed. If this happens, empty the Ashpan and restart
the Furnace.
3. The slide out bottom. (See figure 19) Now you are ready to drop the clinker from
the burn pot. Pull the bottom out in one quick motion and let the clinker drop into
the ash pan. Quickly push the bottom in again. To pull out the slide bottom use
the Rod Handle tool shown in figure 20 on page 39.
Figure 19