Instructions / Assembly

LIGHTING THE HEATER:
Initial Lighting Instructions (To be used on initial  ring)
Push shut-off lever (inside the hopper) down, turn heat adjustment lever to low before  lling hopper
with pellers. Fill the hopper around ½ full. This one-time initial  ring needs to be done to cure the
paint on the unit. Put the heat adjustment lever on the LOW setting to limit the number of pellets in
the  repot for the entire initial burn period. Having the heat adjustment lever on the HIGH setting on
initial  ring will result in very high temperatures and potentially damage your heater and voiding your
warranty. Pull the shut off lever (inside the hopper) up and lock in place. Light the pellets and let it burn
through all the pellets and allow the heater to cool down. You are now free to use the heater according
to the remainder of these instructions. These initial lighting instructions allow the high temperature
paint to cure properly. When curing, the paint will give off some smoke and this will happen for the  rst
15 minutes.
5
OPERATING THE HEATER:
1. Make sure your heater has been assembled properly.
2. Push the shut-off lever down (inside pellet hopper).
3. Fill hopper with pellets. The pellets will not fall into the  repot at this point since the shut-off
lever is closed.
4. Open the door and make sure the heat baffle is centered around the  repot
5. Pull the shut-off lever up and lock in place (inside pellet hopper). This will allow pellets to fall into
 repot.
6. Squirt a small amount lighter  uid or gel onto the pellets and ignite with a butane lighter or match
and close the door.
7. Once the pellets have caught  re after 5 minutes or so you can put the heat adjustment lever in
the High or Low setting.
8. Keep the door closed when using the heater. If the door is open, the heater will lose its draft and
the pellets will not burn properly.
9. Occasionally operate the ash cleanout handle to allow ash to drop into ash tray.
10. After several hours of use you may have excess pellets piled up at the bottom of the chute, you wil
need to open the door and use the rake tool and pull pellets toward the front of the heater. This
only needs to be done after several hours of use to help ensure maximum heat ouput.