Installation Manual
FCC REGULATORY STATEMENTS
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions.
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment should be installed and operated with a minimum distance of 20 cm
between the radiator and any part of the human body.
US contact information:
335 Madison Ave., 4th Floor
Grand Central Tech
New York, NY 10017, USA
+1 (646) 930-6305
info@evbox.us
Canadian Regulatory Statements
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
(FR) Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de
l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.
Under Industry Canada regulations, this radio transmitter may only operate using
an antenna of a type and maximum (or lesser) gain approved for the transmitter by
Industry Canada. To reduce potential radio interference to other users, the antenna
1. safety regulations
65
type and its gain should be so chosen that the equivalent isotopically radiated
power (e.i.r.p.) is not more than that necessary for successful communication.
(FR) Conformément à la réglementation d’Industrie Canada, le présent émetteur
radio peut fonctionner avec une antenne d’un type et d’un gain maximal (ou
inférieur) approuvé pour l’émetteur par Industrie Canada. Dans le but de réduire
les risques de brouillage radioélectrique à l’intention des autres utilisateurs, il faut
choisir le type d’antenne et son gain de sorte que la puissance isotrope rayonnée
équivalente (p.i.r.e.) ne dépasse pas l’intensité nécessaire à l’établissement d’une
communication satisfaisante.
This equipment complies with the ICES RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with a
minimum distance of 20cm between the radiator and any part of the human body.
(FR) Cet équipement est conforme aux limites d’exposition aux radiations ICES
dénies pour un environnement non contrôlé . Cet équipement doit être installé et
utilisé à une distance minimale de 20 cm entre le radiateur et une partie de votre
corps.
Note: This device, when operated in the band 5150–5250 MHz, is only for indoor
use to reduce the potential for harmful interference to co-channel mobile satellite
systems.
(FR) Tout appareil destiné à la bande 5150 – 5250 MHz devra être exclusivemenl
utilisé en intérieur a n de réduire les risques de pertuarbatians électromagnétiques
gênantes sur les systémes de satellite mobile dans un même canal”
Note: Some electric vehicles require an external ventilation system to prevent the
accumulation of hazardous or explosive gasses when charging indoors. Consult the
vehicle’s owner manual to determine whether or not your electric vehicle requires
ventilation during charging. This charging station is not designed for charging these
vehicles and must not be used for charging electric vehicles that require external
ventilation.
Transport and storage
Ensure that the main power source has been disconnected when storing or
transporting the charging station. No liability can be accepted for damage during
the transportation process if the charging station is transported in anything other
than its original packaging.
Store the charging station in a dry environment. The product is preferably stored
at room temperature. If this is not possible, storage temperature must be between
50°F and 113°F with a maximum humidity level of 95% non-condensing.
EVBox strives to manufacture products of the highest quality. EVBox products for
the US market are UL 2594 tested and compliant. For the Canadian market, they
are CSA C22.2 No. 280-16 tested and compliant. For the EU market, they are CE
certied and compliant with the essential requirements of
EMC Directive 2014/30/EU and Low Voltage Directive 2014/35/EU.
More details can be found at evbox.us or in this Installation Manual.
EVBox products are sold with a limited warranty described at
evbox.us/general-terms-conditions.
1. safety regulations