Installation Manual
23
7. charge with Elvi
Start charging
1. Plug Elvi charging cable into your car. If you’re using a cable dock (optional) and
a type 1 cable, press the release button on the cable plug, then release the cable
from the dock, and plug the cable into your car.
2. To start and stop a charging session, you can use a registered charge card, key
fob, or your Hey by EVBox app.
3. Hold your charge card (RFID Card) in front of the reader, marked with icon.
4. Elvi reacts with a beep sound. This means that your card is being authorized.
5. Elvi LED ring turns blue when it starts charging.
Stop charging
1. Hold your charge card (RFID Card) in front of the reader, marked with icon.
2. Elvi reacts with a beep sound. This means that your charge card / keyfob is being
authorized. Elvi LED ring turns green when it stops charging.
3. Unplug Elvi charging cable from your car and place the charging cable back into
Elvi’s cable holder. Alternatively you can unplug your charging cable from your
car directly and end your session.
What you see What it means What to do
LED ring off
or green
Elvi is ready for use. Plug Elvi charging cable into the car.
LED ring
green ashing
Your charge card is being
veried.
Wait until LED ring turns blue.
LED ring
yellow
The car is fully charged. Unplug Elvi charging cable from the car and
place the cable back into Elvi cable holder.
LED ring
yellow ashing
Charging session is in
queue, optionally in Smart
Charging environment
When power becomes available,
charging will start or resume,
and the LED ring will turn blue.
LED ring
blue
Elvi is charging the car. The car is charging.
LED ring
red
Elvi is experiencing
an error.
Check the troubleshooting chapter in this
manual for solutions. If this does not solve the
issue, contact your installer or supplier of Elvi, or
message us at service@evbox.com.
LED ring
red ashing
Your charge card is not
authorized to charge.
Contact your charge card service
operator, or apply for a free authorized charge
card at evbox.com/products.
24