Installation Manual

5. install cable dock
sold separately
The Elvi cable dock is sold separately.
Contact the supplier of your Elvi for details about
options and accessories.
5.1
Unpack your Elvi cable dock.
Disassemble the charging cable holder by
removing the Torx bolt with the T30 bit.
5.2
Place the cable dock’s wall base on a solid and
at surface. Position the cable dock on the wall as
illustrated (it should be to the side of your station
and at a comfortable height within at least 3ft 3
3/8” (1 meter) from the ground).
Use the cable dock’s wall base as a drilling
template to mark the 3 holes to be drilled.
Make sure it is level.
5.3
Drill holes with drill round 5/16” (8 mm).
Use the supplied plugs 8 x 65 mm and screws
6 x 70 mm length.
Tools you need to install the cable dock
19
8mm drill
drilling machine
pencil
3x
screw 6x70mm
3x
plug 8x65mm
Included
in the box
Not
included
in the box
Bit T30
~ W 300 mm
H 65 mm
5. install cable dock
5.4
Place the cable dock’s wall base on the wall and fasten
the screws.
Do not overtighten.
5.5
The Elvi cable dock is supplied with two plug holder
options: one for Type 1 (SAE J1772) and one for Type 2
(IEC 62196) charging plugs.
Choose the plug holder that corresponds to your
charging cable and insert it into the cable dock.
Fasten the bolt removed in step 5.1 with the T30 bit.
Do not overtighten.
Success!
You’re all set.
20