User Manual

30
EN
Post-installation checklist
• Power on only the Hub at rst, for Satellites follow “Assigning the correct connector IDs
for each station/port” (see below).
• The LED ring must be solid green when in the ready state.
• Check all the connectors on the controllers.
• Measure the voltage and current at the terminal block. For split phase 120V system,
the voltage between L1 and L2 should be above 180V.
• Initiate a charge session using an electric vehicle or an EVSE tester.
• The LED ring should turn blue when the charge session is in progress.
• For networked stations, call the number on the charging unit to commission the station.
For units that are RFID only, email [e-mail].
Assigning correct connector IDs to each station/port
• The Hub unit (with communication module) comes with a pre-installed top label with the
QR code (station ID) and connector ID #1.
• Included in the box with the Hub unit, there are an additional 9 top labels for Satellites
with the same QR code (station ID) but different connector IDs (#2-10).
• Assigning connector IDs to Satellites:
- The Hub is assigned connector ID #1 (the Hub should be powered on rst)
- All the Satellites need to be powered on one at a time. The rst satellite to be
powered on will automatically be assigned connector ID #2. The second satellite
to power on will be assigned connector ID #3, and so on.
- After all Satellites are powered on, call the network provider or use their mobile
app to start a charging session on each connector. Once the connector ID is
conrmed for all the Satellites, apply the corresponding top label.
Maintenance
The owner or user is responsible for the maintenance of the charging station, whereby both
the law regarding the safety of persons, animals, property must be observed, as well as the
installation regulations in force in the country of use.
• Dirt on the outside of the charging station can be cleaned off using a soft damp cloth.
• Regularly check the EV plug for damage and for foreign matter inside the EV plug.
• To protect the charge cable when not in use, an EV plug holster for pole mounted
charging stations is available as an option.
• The EV plug holster is available with options for pole mounting of dual EV plug, single
EV plug and wall mounting of a single EV plug. Contact your local EVBox representative
for details.
Accessories
Cable wrap and holster for BusinessLine Double on a pole or wall – (PN# 290120)
Cable wrap for a BusinessLine Single on a pole – (PN# 290121)
Cable wrap for a BusinessLine Single on a wall – (PN# 290122)