User Manual

23
EN
Pole mounting for BusinessLine Double
Mounting the dual unit on the CombiPole does
not require an adapter kit.
• Snake the power cables to the top of the
pole. Keep at least 2.5 feet of slack for
the power cable to reach the top of the
charging station.
• Slide the BusinessLine Double onto the
pole, snaking the power cables through
the center cavity towards the top of the
unit where the terminal block is located.
Note: The BusinessLine Double requires
two power inputs.
• Make sure not to trap any wires during
the process.
• Afx the station to the pole by tightening
the two M10 bolts on either side of
the metal tube clamp (see following
illustration).
• Secure the charging station to the pole by
screwing the M5 bolt through the hole at
the bottom of the station (see following
illustration).
Step 3: Mounting the BusinessLine
3a. Pole mounting
Pole mounting for BusinessLine Single
Mount the adapter kit as shown on page 18.
• Mount the screws as shown.
• Run the power cables out of the hole in the
center of the adapter kit and through the
hole in the backplate of the station.
• Align the holes on the back plate of the unit
with the screws on adapter kit.
• Hang the unit onto the screws and pull the
unit down to secure it.
• Tighten the screws.
To see how to mount your station to the retractor system, skip ahead to page 24.