User Manual

20
EN
To see how to mount your station to the CombiPole, skip ahead to
page 22.
2b. Mounting on a wall
Mounting a BusinessLine Single
• A wall spacer is used to mount a BusinessLine Single onto
a wall.
• Choose a solid and at vertical mounting surface to install the
wall spacer (PN#290190). The wall should be able to hold at
least 60 lbs.
• Drill holes onto the at surface to install the wall spacer using
the holes on the wall spacer.
• Power supply conduit can enter the unit through the top,
bottom, or side of the wall spacer.
• Lead the power cables out of the hole in the center of the wall
spacer. EVBox BusinessLine will mount onto the wall spacer.
• A wall mount cable holster is also available for
cable management.
Mounting a BusinessLine Double
• A wall mount bracket is used to mount a BusinessLine Double onto a wall.
• Choose a solid at vertical mounting surface to install the wall bracket. PN#290600
(The wall should be able to hold at least 100 lbs).
• Drill holes onto the wall, aligning it with the holes on the base plate of the wall mount
bracket as shown in illustration on the following page.
• Power supply cables enter the bracket as shown in the illustrations on the following page.
• Lead the power supply cables all the way through the bracket. The BusinessLine Double
slides onto the top of the bracket.
• To see how to mount your station to the wall bracket, skip ahead to “Pole mounting for
BusinessLine Double” on page 22.