User Manual
12
EN
Operation
• A charging session may be started by simply plugging the car in (Autostart),
using an RFID card, or by using a QR code (depending on your selected conguration).
• The charging station is equipped with a self-testing internal residual current leakage
detection device that will stop the charging process if current leakage (AC or DC)
is detected.
• Charging will only start if the charging cable is properly connected to the electric vehicle.
Some models are congured to start charging automatically when the charging cable is
properly connected to the vehicle.
Charging at a station using a QR code (for networked units)
1. Download the network provider’s app to your smartphone and sign up (rst-time use only).
2. Provide the requested details (if applicable, rst time use only).
3. Connect your vehicle to the charge port.
4. Scan the QR code using the mobile app, or manually enter the charge station ID located on
the QR label to start charging.
5. To stop charging, unplug the charging cable and reinsert it into the cable holster for the
next user.
Charging at a station using an RFID card or a key fob
1. Connect your vehicle to the charge port.
2. Hold an authorized RFID card or key fob (Mifare Classic, 13.56Mhz) against the RFID reader
at the front of the charging station (see component 2 on page 9).
3. After scanning, the station will blink green for a few seconds while it registers your card.
Once the ring turns solid blue, the charging session is initiated.
4. To stop charging, unplug the charging cable and reinsert it into the cable holster for the
next user.