Instruction Manual

Filling Your Airgun

1) REX: Release the screw on the back stock of gun’s air

tank to be taken out and Insert the probe in the hole.

REX P : Take the cap out on the back of air tank and

insert the probe in the hole

2) Do not use any other type of adapter other than the

one supplied with the rie.

3) Slowly ll the rie to a MAXIMUM of 220 bar

(approximately 3,190 psi) pressure.

4) Filling the rie too fast creates excess heat, and the

gauge may temporarily show an articially high pressure

level. After the reservoir has cooled, the gauge may

show a lower pressure level.

5) Do not overll, as this will damage the gun and

result in low power. Such damage is not covered under

warranty.

6) When charging is complete, bleed the excess air

using the bleed screw on your ll device and remove the

adapter from the rie.

DO NOT LET THE PRESSURE IN YOUR RESERVOIR

DROP BELOW 100 BAR (APPROX. 1450 PSI) BECAUSE

THERE MAY NOT BE ENOUGH PRESSURE TO CLOSE THE BOLT VALVE, AND

ALL REMAINING AIR WILL LEAK OUT. THE GUN WILL HAVE TO BE SENT IN

FOR REPAIR.

WARNING:

USE ONLY COMPRESSED AIR IN THIS AIRGUN. USE NO

OTHER GASES—INCLUDING OXYGEN, WHICH CAN

CAUSE A RE OR EXPLOSION THAT MAY RESULT IN SERIOUS INJURY OR

DEATH.

DISCONNECTING THE FILL HOSE FROM THE AIRGUN WITHOUT BLEEDING

THE AIR FIRST MAY RESULT IN INJURY FROM HOSE WHIP AS A RESULT OF

PRESSURE IN THE FILL HOSE.

DO NOT ATTEMPT TO REPAIR THE AIRGUN OR TO DISASSEMBLE TO COR-

RECT AN OVERFILL OR VALVE LOCK. PARTS CAN FLY FROM THE AIRGUN AT

DANGEROUS SPEEDS WHEN IT IS DISASSEMBLED WHILE PRESSURIZED.

WARNING:

REX

REX-P