Instruction Manual

Using High Air Pressure

USE ONLY COMPRESSED AIR IN YOUR EVANIX AIRGUN.

USE NO OTHER GASES INCLUDING OXYGEN, WHICH

CAN CAUSE A FIRE OR EXPLOSION THAT MAY RESULT IN SERIOUS INJURY

OR DEATH.

DISCONNECTING THE FILL HOSE FROM THE AIRGUN WITHOUT FIRST

BLEEDING THE AIR MAY RESULT IN INJURY FROM HOSE WHIP AS A RESULT

OF PRESSURE IN THE FILL HOSE.

DO NOT ATTEMPT TO REPAIR THE AIRGUN OR TO DISASSEMBLE TO COR-

RECT AN OVERFILL OR VALVE LOCK. PARTS CAN FLY FROM THE AIRGUN AT

DANGEROUS SPEEDS WHEN IT IS DISASSEMBLED WHILE PRESSURIZED.

WARNING:

Slowly ll your rie to a MAXIMUM of 220 bar (approximately 3,190 psi).

Filling the rie too fast is unsafe and creates excess heat that may result in a low or

inaccurate ll pressure.

Do not overll, as this will damage your gun and result in low power. Such damage is not

covered under warranty.

When lling is complete, bleed the excess air using the bleed screw on your ll device.

Only then can you safely remove the adapter from the rie.

Read this entire manual before lling, loading or

shooting your gun!