Instruction Manual

7
Inserting the magazine
Adjusting the trigger
Make sure the rie is unloaded by removing the magazine and
ensure there are no pellets in the breech. Put the gun on SAFE.
Inverttherieandsecureitina
riestandorsimilarstabilizing
device. Remove the stock.
First-stage adjustment
The adjustment screw for the
rststageissituatedinthe
section underneath the trigger
blade. Using a 1.5mm Allen
key, turn the screw clockwise
To insert the magazine,
pull the sidelever to
open the bolt.
Next, slide the loaded
mag into the breech
until it "clicks." Failure
to properly seat the
mag could cause the
gun to jam.
To remove the
magazine, pull the
sidelever to open the
bolt and push out the
magazine.