Instruction Manual

3
Filling the rie
AttachtheEvanix-suppliedadaptertotheprobeofyourlldevice.
Read additional directions
on page 4 and follow the
warnings on page 11.
1. Rotate the front of the
gun’s air tank to allow
access. Insert the probe in
the hole.
2. Do not use any other type
of adapter other than the
onesuppliedwiththerie.
3. Slowlylltherietoa
MAXIMUM of 200 bar
(approximately 2,900 psi)
pressure.
4. Fillingtherietoofast
creates excess heat, and
the gauge may temporarily
showanarticallyhigh
pressure level. After the
reservoir has cooled, the
gauge may show a lower
pressure level.
5. Do not overll, as this
will damage the gun and
result in low power. Such
damage is not covered
under warranty.
6. When charging is
complete, bleed the excess
air using the bleed screw
onyourlldeviceand
remove the adapter from
therie.