Instruction Manual
Filling the rie
To ll the Monster and Windy City air ries: Attach the Evanix-supplied adapter to the probe
of your ll device.
WARNING:
4
Monster ll port & adapter shown above. Windy City ll port & adapter shown above.
Use only compressed air in this airgun. Use no other gases—including oxygen,
which can cause a re or explosion that may result in serious injury or death.
Disconnecting the ll hose from the airgun without bleeding the air rst may
result in injury from hose whip as a result of pressure in the ll hose.
Do not attempt to repair the airgun or to disassemble to correct an over ll or
valve lock. Parts can y from the airgun at dangerous speeds when it is disassem-
bled while pressurized.
For all Evanix air ries: Do not use any other type of adapter other than the one supplied
with the rie. Slowly ll the rie to a MAXIMUM of 200 bar (approximately 2,900 psi)
pressure. Filling the rie too fast is unsafe and creates excess heat that may result in a low
or inaccurate ll pressure. Do not overll as this will damage the gun and result in
low power. Such damage is not covered under warranty.
Leopard ll port shown above.
When charging is complete, bleed the excess air using the bleed screw on your ll device
and remove the adapter from the rie. Special procedure for the Leopard: Rotate the
protective cover when done to prevent contamination of the ll port.
To ll the Leopard air rie: Attach the
stainless steel ll adapter to the correct ll
equipment. Rotate the ll port’s protective
cover to allow access. Insert the ll adapter
into the ll port.